Choosing A Language; Selecting A U.s. Standard Or Metric Display - Precor 954i Owner's Manual

Choosing a Language

The equipment can display user prompts, text, and user entries in
seven different languages. When the equipment is shipped from the
factory, it is set to display English.
Note: Programming prompts are not affected by language selection.
The prompts in this section continue to appear in English.
4. At the SELECT LANGUAGE prompt, press OK. Use the
navigational arrow keys to choose a language
5. When you are ready, press OK to accept the displayed setting and
move to the next feature. For other options, refer to Table 3.
Product Owner's Manual: Club Features
Selecting a U.S. Standard or
Metric Display
The equipment can display measurements in either Metric or U.S.
Standard. The default factory setting is set to display U.S. Standard.
To change this setting, perform the following steps:
6. At the SELECT UNITS prompt, press OK. Use an arrow key to
select a unit of measure (U.S. or METRIC).
CAUTION: If you change the Unit of Measure display, be sure
to check the speed setting on the treadmill to verify that it is
correct. Refer to Treadmill: Determining the Club Speed Limit.
7. When you are ready, press OK to accept the displayed setting and
move to the next feature. For other options, refer to Table 3.
16