Recumbent Cycle: Realigning The Seat - Precor EFX546i Owner's Manual

Recumbent Cycle: Realigning the Seat

If the seat rocks side-to-side, you need to realign the center wheel
underneath the seat. Adjustment screws are located on the left
side of the seat rail.
To remove seat wobble (side-to-side movement), take the following
steps.
1. Obtain a -inch and
2. Use the -inch hex key to loosen the two adjustment screws as
shown in the following figure.
Figure 7: Loosen the two adjustment screws
Product Owner's Manual: Maintenance
-inch hex key.
3. Use the -inch hex key to turn the wheel lock adjustment key
clockwise ¼ turn as shown in the following figure. This process
realigns the center wheel inside the top rail. Leave the
hex key in place while you tighten the adjustment screws with
the -inch hex key.
Figure 8: Wheel lock adjustment
4. Remove the hex keys and check that the seat no longer rocks
side-to-side. If the rocking movement continues, you need to
repeat steps 2 and 3.
-inch
38