Log Placement - Napoleon GD36NTR Installation And Operation Instructions Manual

28

LOG PLACEMENT

TM
PHAZER logs and glowing embers exclusive to Napoleon
Fireplaces, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position
the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the fi replace,
the colours will become more uniform as colour pigments burn
in during the heat activated curing process.
SIDEVIEW
1. Place the back log (#1) onto the log
support tray and in front of the tabs. The
tabs maintain an air space between the log
and fi rebox back to facilitate combustion air
fl ow. Ensure that the back of the log rests
against the brackets on the back wall of the
fi rebox.
TAB
2. Move the two small logs (#2 & #3) into position, lining up
the studs located on the burner with the holes on the bottom
of the logs. Ensure that the small logs sit fl at on the burner.
3. Place the bottom of the left crossover log (#4) against
the left fi rebox side and pulled forward to the grate.
The top of the log should rest in the pocket on the back log.
W415-0210 / R / 02.27.08
NorthlineExpress.com
FIGURE 57 a-f
4. Position the base end of the center log (#5) against the
middle grate post with the other end of the log resting in the
pocket of the left crossover log.
5. Place the bottom of the right crossover log (#6) against
the right fi rebox side and pulled forward to the grate. The top
of the log should rest in the pocket provided on the center
log (#5).
Randomly place the charcoal embers along the front and sides
of the log support tray in a realistic manner. Fine dust found
in the bottom of the bag should not be used.
VERMICULITE (MODEL GD36 ONLY)
Sprinkle vermiculite around the charcoal embers.
Note: Both charcoal embers and vermiculite are not to
be placed on the burner.
Tear the embers into pieces and place along the front row
of ports covering all of the burner area in front of the small
logs (#2 & #3). Care should be taken to shred the embers
into thin, small irregular pieces as only the exposed edges of
the fi bre hairs will glow. The ember material will only glow
when exposed to direct fl ame; however, care should be
taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern,
carbon deposits and delayed ignition. PHAZER
when exposed to direct fl ame. Use only certifi ed "glowing
embers" and PHAZER
dealer.
Remove the backing of the logo
supplied and place on the glass
viewing door, as indicated.
http://www.northlineexpress.com
CHARCOAL EMBERS
GLOWING EMBERS
TM logs available from your Napoleon
LOGO PLACEMENT
½"
LOGO
FIGURE 58
TM logs glow
½"
Toll-Free 1-866-667-8454