Setting Up The Printer - Epson TM-U200D series Operator's Manual

4. Use the following tables to set the DIP switches. Numbers
starting with 1 are in the first set, and numbers starting with 2
are in the second.
Model with serial interface DIP-Switch Functions
DIP Switch Set 1
Switch Function
1-1 Data reception error
Receive buffer
1-2
capacity
1-3 Handshaking
1-4 Word length
1-5 Parity check
1-6 Parity selection
1-7 Baud rate
1-8 Busy condition
DIP Switch Set 2
Switch Function
2-1 Print column selection
7 × 9 font/9 × 9 font
2-2 Internal use. Setting must not be changed. (Fixed to Off).
2-3 I/F pin 6 reset signal
2-4 I/F pin 25 reset signal
2-5 Internal use. Setting must not be changed. (Fixed to Off).
2-6 Internal use. Setting must not be changed. (Fixed to Off).
2-7 Internal use. Setting must not be changed. (Fixed to Off).
2-8 Undefined.
ON
Ignored
40 bytes
XON/XOFF
7 bits
Yes
Even
4800 BPS
Sets the printer to go
BUSY when the
receive buffer is full
ON
42/35
Enabled
Enabled
Setting Up the Printer 1–19
OFF
Prints"?"
Approx. 1K
bytes
DTR/DSR
8 bits
No
Odd
9600 BPS
Sets the printer to
go BUSY when it is
offline or the
receive buffer is full
OFF
40/33
Disabled
Disabled