Setting The Dip Switches - Epson TM-U200D series Operator's Manual

Setting the DIP Switches

CAUTION:
Turn off the printer while removing the DIP switch cover to
prevent an electrical short, which can damage the printer.
You can change your serial interface and print column settings by
changing the DIP switch settings.
1. Make sure that the printer is off.
2. Turn the printer over and remove the DIP switch access cover,
as shown below.
3. There are two sets of switches. Notice that ON is marked on
each set of switches. Use tweezers or another narrow tool to
move the switches.
1–18 Setting Up the Printer
SW 1
SW 2