KVH Industries TracVision R4 Owner's Manual page 32

This information has to be entered for each of the following
categories:
• vertical high
• horizontal high
or
• right
TracVision R5/R4 requires that the data fields for all transponder
categories be provided. If the selected satellite does not have
information for one or more of the transponder categories,
default information should be entered in the fields as follows:
Transponder Data
Frequency
Symbol Rate
FEC Code
Network ID
Polarity and Band
@SAVE,A
5. Type
@SAVE,B
settings (or
satellite.)
@DEBUGOFF
6. Type
ZAP
7. Type and press Enter to restart the system.
One of your user-defined satellites has now been added to the
TracVision R5/R4 satellite library. This satellite will now be
available the next time you use the SATINSTALL command.
54-0157 Rev. H
• vertical low
• horizontal low
• left
Default Value
00000
27500
the same value as provided for those
transponders with data
0x0000
whichever combinations are not
already provided
and press Enter to save your
if data is for User2
and press Enter.
Table 2-6
Default Transponder Values
Installation
2-21