KVH Industries KVHTRACVISION G4 Technical Manual page 11

TracVision G4-HP
Technical Manual Addendum
(ECO #7134)
The following changes apply to Revision K of the
TracVision G4-HP Technical Manual (KVH Part Number 54-0147).
The "=TV" configuration command printed in the manual is incorrect.
For your TracVision G4-HP system, the correct configuration command
is =TVG4HPT , not =TVG4HP .
You will need to enter the =TVG4HPT command whenever you replace
the main printed circuit board (PCB) or calibrate the antenna gyro, at
the steps noted below.
5.4 Replacing the Main PCB and
Fuses
Replacing the Main PCB
=TVG4HPT<cr>
13. Type
5.6 Replacing the Antenna Gyro
Assembly
Calibrating the Antenna Gyro
=TVG4HPT<cr>
8. Type
54-0147 Addendum to Rev. K
(<cr> = Press the Enter key).
.
1