Table of Contents
Advertisement
10. Retighten the upholstery straps.
Fig. 75
11. Reattach the upholstery cover.
Fig. 76
6.11 Manual adjustable backrest (manual recline)
For depth adjustment see section 6.3. above. To recline the backrest
angle, pull the lever at the top of the backrest which operates the gas
strut. Hold the lever and adjust the back angle required. If you release
the lever, the angle will stay in the adjusted position. If you want to
adjust the backrest into the upright position, you might need to support
the upward motion
(Fig. 77).
6.12 Manual setting of the seat angle on the SALSA
To set the seat angle, release the bolt fixing the "Banana" bracket
between the seat interface module and the seat packer module. Set the
seat angle at 0°, 3° or 6° and 9°, then replace and re tighten the bolt
between the seat interface module and the seat packer module.
78).
Fig. 78
0°
6°
060474
Fig. 77
3°
9°
6.13 Headrest
To fit the headrest, fit the location bracket to the push handles, using
the screws and nuts supplied, ensuring that they are fully tightened.
The headrest height is changed by loosening the adjustment knob and
sliding the inner vertical tube to the desired position and tightening
the knob. The headrest to seat depth is adjusted by loosening the 6mm
Allen screws and moving the hinge to the desired position and then
tightening the screws securely. To adjust the headrest angle, loosen
the screws at the headrest upholstery, position the headrest as required
and tighten the screws securely. (Fig. 79 - 82)
Fig. 79
Fig. 80
Fig. 81
(Fig.
Fig. 82
23
Quickie SALSA
Advertisement
Table of Contents
