Table of Contents
Advertisement
6.
Replace both sets of armrest adjustment ring bolts according to
the configuration chart.
(Use 10 N/m or 88.5in/lb of torque.)
Fig. 32
7.
Replace both armrest assemblies.
Fig. 33
8.
Replace the armrest pivot bolts on both sides of the seat.
Do not tighten completely.
Fig. 34
16
Quickie SALSA
Fig. 31
PART II: ARMPAD ANGLE ADJUSTMENT
9.
Loosen the 4mm armpad angle pivot bolts (A) on both armrests.
Remove the 4mm angle index bolts (B) on both armrests.
Fig. 35
10. Use the 5mm fine height adjustment screw (C) to finish fine
tuning the height. Turn counter-clockwise to increase height or
clockwise to lower.
Fig. 36
11. Tilt both armpads down (or up in the case of a lowered armrest)
until the armpads are in the preferred angle. Check to see if the height
is correct. (Refer to Number 10 for further height adjustment.)
Fig. 37
12. Retighten both armrest pivot bolts. (Use 20 N/m or 177 in/lb of
torque.)
Fig. 38
060474
Advertisement
Table of Contents
