Table of Contents
Advertisement
13. Retighten both armpad angle pivot bolts (A). Replace both armpad
angle index bolts (B). (Use 10 N/m or 88.5 in/lb of torque for both sets
of bolts.)
Fig. 39
5.8.3
Armpad Position Adjustment (Fig. 40 - 44)
1.
Fine armpad position adjustments (one to two inches) are possible
by loosening the 4mm armpad adjustment bolts (E) and sliding the
armpad forward or backward as required.
Access to the rear adjustment bolt may require pivoting the armpad.
NOTE– If more than one to two inches of adjustment is required, refer
to chart below and continue to Number 3.
Fig. 41
060474
Fig. 40
2.
Retighten both adjustment bolts (E).
(Use 10 N/m or 88.5 in/lb of torque.)
Fig. 42
3.
For larger adjustments, remove both sets of armpad adjustment
bolts.
4.
Slide both armpads to the next set of attachment holes (refer to
the chart). Retighten both sets of armpad adjustment bolts. (Use 10
N/m or 88.5 in/lb of torque.)
Fig. 43
Fig. 44
17
Quickie SALSA
Advertisement
Table of Contents
