Table of Contents
Advertisement
10. Retighten the upholstery straps.
Fig. 80
11. Reattach the upholstery cover.
Fig. 81
6.11 Manual adjustable backrest
(manual recline)
For depth adjustment see section 6.3.
above. To recline the backrest angle, pull
the lever at the top of the backrest which
operates the gas strut. Hold the lever
and adjust the back angle required. If you
release the lever, the angle will stay in the
adjusted position. If you want to adjust
the backrest into the upright position, you
might need to support the upward motion
6.12 Manual setting of the seat angle on the SALSA
To set the seat angle, release the bolt fixing the "Banana"
bracket between the seat interface module and the seat packer
module. Set the seat angle at 0°, 3° or 6° and 9°, then replace
and re tighten the bolt between the seat interface module and
the seat packer module.
(Fig.
Fig. 83
24
Quickie SALSA
Fig. 82
(Fig. 82).
83).
0°
6°
6.13 Headrest
To fit the headrest, fit the location bracket to the push handles,
using the screws and nuts supplied, ensuring that they are fully
tightened.
The headrest height is changed by loosening the adjustment
knob and sliding the inner vertical tube to the desired position
and tightening the knob. The headrest to seat depth is adjusted
by loosening the 6mm Allen screws and moving the hinge to
the desired position and then tightening the screws securely.
To adjust the headrest angle, loosen the screws at the headrest
upholstery, position the headrest as required and tighten the
screws securely. (Fig. 84 - 87)
Fig. 84
Fig. 85
Fig. 86
3°
Fig. 87
9°
Advertisement
Table of Contents
