Toshiba RAS-B10SKVP-E Service Manual page 106

No. Part name
Rear 1) Perform work of item 1. of
5
cabinet
2) Remove fixed screws fixing to the bottom plate.
3) Remove fixed screws fixing to the heat
4) Remove fixed screw fixing to the valve mounting
Fan motor 1) Perform work of item 1. of
6
2) Remove the flange nut fixing the fan motor and
3) Remove the propeller fan.
4) Disconnect the connector for fan motor from the
5) Remove the fixing screws (3 pcs.) holding by
7 Compressor 1) Perform work of item 1. of
2) Evacuate refrigerant gas.
3) Remove the partition board.
4) Remove the sound-insulation material.
5) Remove terminal cover of the compressor, and
6) Remove pipe connected to the compressor with
7) Remove the fixing screw of the bottom plate and
8) Remove the fixing screw of the bottom plate and
9) Pull upward the refrigeration cycle.
10) Remove nut fixing the compressor to the
8 Reactor 1) Perform work of item 1. of
2) Remove screws fixing the reactor.
Procedure
(ST1TØ4 × 8L 2 pcs.)
exchanger. (ST1TØ4 × 8L 2 pcs.)
plate. (ST1TØ4 × 8L 1 pc.)
the propeller fan.
• Flange nut is loosened by turning clockwise.
(To tighten the flange nut, turn counterclockwise.)
inverter.
hands so that the fan motor does not fall.
(ST1TØ4 × 8L 3 pcs.)
disconnect lead wire of the compressor thermo.
and the compressor from the terminal.
a burner.
heat exchanger. (ST1TØ4 × 8L 1 pc.)
valve mounting plate.
(ST1TØ4 × 8L 2 pcs.)
bottom plate.
(ST1TØ4 × 8L 2 pcs.)
3
, 2 and .
1
and .
1 2
4 5
1 , 2 , 3 , and .
, and 3 .
1
– 106 –
Remarks
Fan motor
Propeller fan
Flange nut
Partition board
Compressor
thermo.
Compressor
Reactor
Valve
mounting
plate