Toshiba RAS-B10SKVP-E Service Manual page 104

Split type
Hide thumbs Also See for RAS-B10SKVP-E:
Table of Contents

Advertisement

No.
Part name
Inverter
1. Detachment
3
assembly
Be careful to check the inverter because
high-voltage circuit is incorporated in it.
Be careful to discharge the capacitor
because the electrolytic capacitor cannot
naturally discharge and voltage remains
according to trouble type in some cases.
This capacitor i one with mass capacity.
Therefore, it is dangerous that a large
spark generates if short-circuiting
between
etc. for discharging.
As each connector has a lock mecha-
nism, avoid to remove the connector by
holding the lead wire, but by holding the
connector.
Procedure
1) Perform work of items 1. of
2) Remove screw (ST1TØ4 × 8L 1 pc.) of the
upper part of the front cabinet.
• If removing the inverter cover in this
condition, P .C. board can be checked.
• If there is no space in the upper part of
the upper cabinet, perform work of
3) Perform discharging by connecting
polarity by discharging resistance (approx.
100Ω, 40W) or plug of soldering iron to
terminals of the C15 (printed "CAUTION
HIGH VOLTAGE" is attached.) electrolytic
capacitor (500µF) on P .C. board.
NOTE
,
polarity with screwdriver,
4) Remove screw (ST1TØ4 × 8L 1 pc.) fixing
the main body and the inverter box.
5) Remove various lead wires from the holder
at upper part of the inverter box and wiring
holder at right side of the terminal block.
6) Remove the lead wire from the bundled
part at left side of the terminal block.
7) Pull the inverter box upward.
8) Disconnect connectors of various lead
wires.
Requirement
and
.
2
1
.
2
,
,
The connector is one with lock, so
remove it while pushing the part
indicated by an arrow.
Be sure to remove the connector
by holding the connector, not by
pulling the lead wire.
– 104 –
Remarks
Inverter cover
P . C. board
(Soldered surface)
Discharging position
(Discharging period
10 seconds or more)
Adjust length of every lead wires
other than complete and case
thermo., and bundle them.
TO sensor
P.M.V. coil
TGa, TGb, TGc
(A, B, and C rooms)
sensor
Plug of
soldering
iron
Holder

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents