Yamaha F225A Service Manual page 239

Upper case, steering arm, swivel bracket and clamp brackets
2. Install the oil strainer 4 and bolts, and
then tighten the bolts to the specified
torque.
Oil strainer bolt:
10 N·m (1.0 kgf·m, 7.2 ft·lb)
3. Install the oil pan 5, and then tighten the
bolts finger tight.
4. Install the exhaust manifold 6 and bolts,
and then tighten the bolts finger tight.
5. Tighten the exhaust manifold bolts 7,
then the oil pan bolts 8, and then tighten
them to the specified torques.
69J3D11
Exhaust manifold bolt 7:
20 N·m (2.0 kgf·m, 14 ft·lb)
Oil pan bolt 8:
20 N·m (2.0 kgf·m, 14 ft·lb)
6. Install the plate 9.
7. Install the cooling water pipe 0 into the
muffler A.
8. Install the muffler A and bolts into the oil
pan, and then tighten the bolts to the
specified torque.
Muffler bolt:
20 N·m (2.0 kgf·m, 14 ft·lb)
9. Install the muffler assembly B by insert-
ing the tip of the cooling water pipe C
into the joint hole a of the upper case.
10. Install muffler assembly bolts D and E,
and pressure control valve F, and then
tighten them to the specified torques.
1
2
3
4
5
6
7
8
9
7-14