POWR
6. Install half of the bearings 9 into the cyl-
inder block 0.
7. Insert the projection f of the bearing into
the notch in the cylinder block.
E
NOTE:
Install the main bearings in their original posi-
tions.
8. Set the crankshaft A, and oil seal B,
and thrust bearings C into the cylinder
block as shown.
NOTE:
Apply engine oil to the inner oil seal and the
thrust bearings before installation.
9. Install half of the bearings D and the
thrust bearing E into the crankcase.
NOTE:
Install the main bearings in their original posi-
tions.
5-57
Power unit
S69J5F10
10. Apply Gasket Maker
face of the crankcase.
11. Insert the projection g of the bearing into
the notch in the crankcase.
NOTE:
Do not get any Gasket Maker on the journal
bearings.
12. Install the crankcase onto the cylinder
block, and then tighten the crankcase
bolts to the specified torques in two
stages and in the sequence shown.
CAUTION:
Crankcase bolts 1–F can be reused five
times.
®
to the mating sur-
69J3D11