Yamaha F225A Service Manual page 205

Ring nut wrench 9: 90890-06578
5. Install the propeller shaft assembly in the
reverse direction into the lower case.
6. Install the ring nut 0 and claw washer
A, and then tighten the ring nut to the
specified torque.
Ring nut wrench 9: 90890-06578
69J3D11
Propeller shaft housing (counter rotation model)
7. Install the forward gear B, original
NOTE:
Install the dog clutch D with the "F" mark e
facing toward the forward gear.
CAUTION:
Add or remove shim(s), if necessary,
when replacing the forward gear or taper
roller bearing.
8. Install the shift plunger E and slider F
Ring nut 0:
108 N·m (10.8 kgf·m, 78 ft·lb)
shim(s) C, and dog clutch D using a
press.
Ring nut wrench 9: 90890-06578
into the propeller shaft, and then install
the cross pin G and spring H.
1
2
3
4
5
6
7
8
9
S69J6445
6-44