Yamaha F225A Service Manual page 134

POWR
Valve seat cutter holder:
90890-06316
Valve seat cutter:
30° (intake and exhaust):
90890-06327
45° (intake and exhaust):
90890-06325
60° (intake and exhaust):
90890-06324
2. Cut the surface of the valve seat with a
45° cutter by turning the cutter clockwise
until the valve seat face has become
smooth.
É
a Slag or rough surface
CAUTION:
Do not over cut the valve seat. Be sure to
turn the cutter evenly downward at a pres-
sure of 40–50 N (4–5 kgf, 8.8–11 lbf) to
prevent chatter marks.
3. Use a 30° cutter to adjust the contact
width of the top edge of the valve seat.
5-37
Power unit
b Previous contact width
4. Use a 60° cutter to adjust the contact
width of the bottom edge of the valve
seat.
b Previous contact width
5. Use a 45° cutter to adjust the contact
width of the valve seat to specification.
b Previous contact width
c Specified contact width
6. If the valve seat contact area is too wide
and situated in the center of the valve
face, use a 30° cutter to cut the top edge
of the valve seat, a 60° cutter to cut the
bottom edge to center the area and set
its width.
30°
S69J5880
60°
S69J5890
45°
S69J5900
69J3D11