Adjusting Handlebar Position - KTM 450 EXC-R EU Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Adjusting handlebar position

1 0 0 1
2 0 0 2
0 0 1
1
2 0 0 2
3 0 0 3
4 0 0 4
5 0 0 5
6 0 0 6
7 0 0 7
8 0 0 8
9 0 0 9
x
(EXC-R EU, EXC-R AUS/UK, EXC-R USA, XCR-W)
1 0 0 1
Remove the four screws
bar and lay it to one side.
2 0 0 2
Info
Protect the motorcycle and its attachments from damage by covering
them.
Do not bend the cables and lines.
Remove the two screws
400223-10
Check parts for damage and wear. Replace damaged or worn parts.
Place the handlebar support in the required position. Fit and tighten the two
screws
Specification
Screw, handlebar support M10
Info
Position the left and right handlebar supports evenly.
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
Position the handlebar clamp. Fit and evenly tighten the four screws
Specification
Screw, handlebar clamp
Info
Make sure the gap width is even.
(EXC-R SIX DAYS)
Remove the four screws
ers and elastomers
Remove the handlebar and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering
them.
Do not bend the cables and lines.
Remove the lower shells
Remove the clamp bar
Remove the two screws
Check parts for damage and wear. Replace damaged or worn parts.
400343-10
. Remove the handlebar clamp. Remove the handle-
. Remove the handlebar support.
.
. Remove the handlebar clamps
.
.
with the rubber cones
. Remove the handlebar support.
®
40 Nm Loctite 243™
(29.5 lbf ft)
M8 20 Nm
(14.8 lbf ft)
with rubber wash-
.
48
.