Table of Contents
Advertisement
2.11 Configuring IP Address for the Switch
The switch is shipped with the following factory default settings for software management :
Default
IP address of the switch : 192.168.0.2 / 255.255.255.0
The IP Address is an identification of the switch in a TCP/IP network. Each switch should be desig-
nated a new and unique IP address in the network. Refer to Telnet management interface.
To change the default IP address Use Telnet IP menu.
2.12 Configuring User Name and Password
The switch is shipped with the following factory default settings for software management :
•
User name : admin
•
Password : 123
The user name and password are used for authentication in accessing to the switch via Telnet interface
and Http web-based interface. For security reason, it is recommended to change the default settings
for the switch before deploying it to your network. Refer to Telnet management interface.
To change user name and password
2.13 Configuring SNMP Settings
The switch is shipped with the following factory default settings for SNMP software management :
Community strings :
The community strings are used for authentication in accessing to the switch via SNMP protocol. For
security reason, it is recommended to change the default settings for the switch before deploying it to
your network. Refer to Telnet management interface.
To change Community strings Use Telnet SNMP menu
2.14 Configuring Port 7 and Port 8
If a 100FX is provided on Port 7 or Port 8 and 100FX fiber connection is selected, configure the port to
auto-negotiation disabled, 100M, and full duplex. Refer to Telnet management interface.
To change port configuration
Use Telnet Security Manager menu
public with access right - read only
Use Telnet Port Config menu
-25-
Advertisement
Table of Contents
