Table of Contents
Advertisement
Page 4-6
4.2
Navigating the EN-4000's Management
System
4.2.1 Saving or Discarding Changes
Buttons to Reset, Save, or Save & Apply are displayed in the lower righthand
corner of EN-4000 configuration screens. You can use them as described below:
• Select the Save & Apply button to save changes that take effect immediately.
• Select the Save button to save changes that will take effect after the EN-4000
is rebooted.
• Select the Reset button to discard changes you have made but have not yet
saved, and to see the screen with its values before you made those changes.
Note: The browser will display a message in the upper right corner of its
screen when there are unsaved changes in the configuration
Note: The browser will also display a message if you use the EN-4000
screens to reboot the chassis before you have saved changes in the
configuration
(Figure
Figure 4-9. Message to Save Configuration before Rebooting
Caution: If you use a rebooting process that is not under the control of the
!
EN-4000 management system's screens—for example, if you close the
browser or if you manually reboot the chassis—you will not see a message
about unsaved changes in the configuration. If you wish to save changes,
make sure you select the Save button or the Save & Apply button before
you close the browser window, or manually reboot the chassis, or use the
screens to reboot.
Note: If you close the browser without saving changes in the configuration,
the previous configuration is used when you reopen the EN-4000
management system in the browser.
Figure 4-8. Message about Unsaved Changes
4-9).
EN-4000™ Reference Manual, Document 4
(Figure
Go to Table
of Contents
4-8).
Advertisement
Table of Contents
