Encore EN-4000 Configuring General Settings page 16

Page 4-16
❖ Fields are opened for a MAC device, as shown in the MAC Device Overrides
Entry Screen
Enter values in the fields shown to override MAC information sent by the
3
EN-4000.
Then do one of the following:
4
a If you wish to configure overrides for another MAC device, return to
b When you have finished configuring overrides, do one of the following:
i If you wish to save the configuration and use it immediately, select Save
and Apply.
ii If you wish to save the configuration, but not to use it until the EN-4000 is
restarted, select Save.
iii If you wish to discard the configuration, select Reset.
4.4 Configuration for the Network
4.4.1 DHCP and DNS
You can configure the EN-4000's use of the Dynamic Host Configuration Protocol
(DHCP) and the Domain Name System (DNS). Confer with your network
administrator to determine values for fields in these configuration screens.
On any EN-4000 management system screen, select the Network tab. Then
1
select the DHCP and DNS tab. (And, if necessary, select the General
Settings tab.)
❖ The browser displays the DHCP and DNS General Settings Screen
(Figure 4-22) for configuration.
(Figure 4-21).
Figure 4-21. MAC Device Overrides Entry Screen
EN-4000™ Reference Manual, Document 4
Go to Table
of Contents
step 2.