Home Theater Master MX-500 Operating Manual page 8

Ml, M2, M3, Power and System Off Buttons
Each of these five buttons are designed to send out up
to 20 series of commands you program into the
buttons. Each one is commonly used to turn on and
turn off all of your A/V components with one button
press, but can be programmed with whatever macro
you desire.
Ten Device Buttons
There are ten device buttons and each of these device
buttons can send out up to 20 programmed commands
when pressed for more than two seconds. It is
typically used in sending out audio input codes so that
the audio receiver will make an automatic input switch
when you press the respective device button on the
remote control, but can be programmed with whatever
macro you desire.
E. Favorite Channel Buttons
You can create up to 50 favorite channel buttons in the
remote control by programming the most frequently
watched channel numbers into these buttons. Each of
these buttons can send out up to 10 commands.
Please refer to page 18 of the manual for programming
the Favorite Channel Programming.
F. Punch Through Operations
The MX-500TM can be setup to operate audio component
volume control buttons (VOLUME UP and DOWN and