Replacement Procedures
4.10 Touch pad
Removing the touch pad
The following describes the procedure for removing the touch pad (See Figure 4-10-1 to 4-
10-2).
1. Peel off the protect Mylar and disconnect the button FFC from the connector on the
touch pad. (Figure 4-10-1)
2. Remove the following screws securing the button bracket.
M2.03.0 Flat BIND screws
3. Remove the following screws securing the button board.
M2.03.0 Flat BIND screws
4. Remove the bracket from the top cover assembly following the arrows. (Figure 4-10-
2)
5. Peel off the touch pad from the top assembly.
Satellite C800 and Satellite L800 Maintenance Manual (960-Q08)
Figure 4-10-1 Remove the touch FFC and screws
x2
x3
30