Replacement Procedures
5. Remove the optical disk drive bezel toward a slope side.
Installing an optical disk drive
The following describes the procedure for installing an optical disk drive.
1. Attach the ODD bracket to an optical disk drive and secure it with the following
screws.
M2.03.0 Flat BIND screw
2. Insert an optical disk drive assembly into the slot and connect it to the connector on
the system board.
3. Secure the ODD drive with the following screw and assemble the ODD bezel(see
figure 4-4-3)
M2 X3 Flat BIND screw
Satellite C800 and Satellite L800 Maintenance Manual (960-Q08)
Figure 4-4-2 Disassemble the side bracket
Figure 4-4-3 Disassemble the ODD bezel
x2
x1
14