Sharp AR-5618 Service Manual page 39

Main Sub
Contents
code code
26 03 Auditor setting
04 Copier duplex setting
05 Count mode setting
06 Destination setting
07 Machine condition check (CPM)
Used to set the auditor.
Code number
0
1
2
* When the coin vendor mode is selected, if the auditor setup is ON and the default tray is bypass
tray, the default tray setup must be changed to the 1st tray.
When this simulation is executed, the current set duplex code number is displayed. Enter the desired
code number of duplex setting and press the [START] key, and the entered code number is set.
Code number
0
1
* When this simulation is executed, the binding margin setup is automatically set to the default
(left side).
When any key input is made, it is displayed on the display section. When the [START] key is pressed,
the set code data are acquired and stored to the count mode set variable and in the EEPROM, and
the machine goes into the sub code input standby mode. However, if the [START] key is pressed
outside the set range, it is not assured. At that time, when the [Interrupt] key is pressed, the data is
not rewritten and the machine goes into the sub code input standby mode. When the [CA] key is
pressed, the simulation is terminated without rewriting the data.
[*1 : Total counter / Developer counter
0: *1= Double count
1: *1= Single count
2: *1= Double count
3: *1= Single count
When this simulation is executed, the current set destination code number is displayed. Enter the
desired code number of the destination and press the [START] key to set the destination.
Code number
0
1
2
3
4
5
6
If this setting is changed, SIM46-19 setting is also changed accordingly.
(The paper size is also changed: AB series is changed to A4, and Inch series to Letter.
The AUTO exposure limit setup is set to the default.
When the destination is changed (from Japan to EX Japan or from EX Japan to Japan),
the maintenance cycle is also set to the default accordingly.)
When this simulation is executed, the current setting of the machine is displayed.
7-seg display
18
20
23
AR-5618S SIMULATIONS 7-9
Details of operation
Mode
Built-in auditor mode
Coin vendor mode
Other
Mode
Without duplex
With duplex
*2 : maintenance counter]
*2= Double count
*2 = Double count
*2= Single count
*2= Single count
Destination
Japan AB series
Inch series
EX Japan AB series
EX Japan inch series(FC)
EX Japan AB series (FC)
China (EX Japan AB series + China paper support)
Taiwan (EX Japan AB series + China paper support)
Meaning (CPM information)
18CPM
20CPM
23CPM
*Default
*Default