10. TECH. REP. MODE
10.3 Machine Adjustment
10.3.1
Tray adjustment
Adjust the paper size from tray 1 to tray 3 and bypass tray.
This adjustment is needed when a paper size is not detected properly.
A. Procedure
1.
Enter the Tech. Rep. mode.
2.
"Tech. Rep. mode menu screen"
Press the [Machine Adjust] key.
3.
A sub menu appears on the right side of the screen.
Press the [Tray Adjustment] key on the sub menu.
4.
"Tray adjustment screen"
Tray adjustment includes the following items. Press the [Next] key or the [Back], and select "1" of the tray you adjust.
[(Tray 1)-1] / [(Tray 1)-2] / [(Tray 2)-1)] / [(Tray 2)-2] / [(Tray 3)-1] / [(Tray 3)-2)] / [(Bypass)-1] / [(Bypass)-2] /
Note
• Be sure to select "1" of the tray you adjust.
5.
Pull out the tray selected. Expand once the paper
guide [1] to the limit and move it slowly in the direc-
tion in which the width is narrowed, and then use a
scale to make the distance between the paper
guides [2] equal to the standard value.
• Standard value: Tray 1 to 3
Bypass tray 210 mm
6.
Set the tray.
7.
"Tray adjustment screen"
Press the [Start] key.
The current position of the selected tray is read in. When the adjustment is done, the message "Complete"
appears.
8.
Press the [Next] key and select "2" of the trays you want to adjust.
Note
• Be sure to select "2" of the tray you want to adjust.
9.
Pull out the tray. Expand once the paper guide to the limit and move it slowly in the direction in which the
width is narrowed to make the distance between the paper guides equal to 279.4 mm (8.5 x 11).
10.
Set the tray.
11.
"Tray adjustment screen"
Press the [Start] key.
The current position of the selected tray is read in. When the adjustment is done, the message "Complete"
appears.
12.
To adjust other trays, repeat steps 4 to 11.
282
250 mm
Field Service Ver2.0 Aug.2005
[1]
[2]
57gaf3c001na