Overview
Effect Size
Insert Effects utilize effect sizes of 1, 2, and 4.
Program (Single or Double mode Program):
Up to three effects with a total effect size of four or less can be inserted in series.
Program (Drum mode Program):
Up to four effects with a total effect size of four or less can be inserted in series/parallel.
Use P5 (DrumKit) in Global mode to assign the DrumKit sounds to Insts 1–4 for each key.
Inst1
Inst2
Inst3
Inst4
Combination:
Up to eight effects with a total effect size of eight or less can be inserted.
Timbre1
Timbre2
Sequencer:
Up to eight effects with a total effect size of eight or less can be inserted.
Track1
Track2
Effect Input/Output
The following table shows the input/output of the Dry sound (the sound without any effect applied) and
the Wet sound (the sound with an effect applied) for each size.
The Size 1 effects are all monaural in/monaural out for both dry and wet sounds. Therefore, Size 1 effects
have monaural input as shown in the figure on the next page. If the Effect On/Off parameter is turned
Off, the effect is bypassed. When a size 1 effect is selected, the bypass sound becomes monaural.
Regardless of the Effect On/Off setting, you can turn all Insert Effects Off by sending the Effect 2
Control message (Controller #92). When the Controller value is 0, all effects turn Off. They turn On
with a value of 1–127.
2
Size
1
Size
Size
Inst1
1
2
Size
Size
Inst2
1
2
Size
1
Size
1
Size
4
Size
Size
Size
1
1
2
Size
4
Size
Size
Size
1
1
2
Dry
Mono In - Mono Out
size1
Wet
Mono In - Mono Out
Dry
Stereo In - Stereo Out
Mono In - Mono Out
Wet
size2
Dry
Stereo In - Stereo Out
size4
Wet
Mono In - Stereo Out
Dry
Stereo In - Stereo Out
Wet
Stereo In - Stereo Out
Shown on the upper left corner of the effect block diagrams.
Size
Size
1
2
Size
Inst1
Inst1
4
Inst3
Inst4
Size
Size
Timbre1
4
Size
Size
Track1
4
Effect
+
Effect
+
Effect
Effect
Effect
Size
Size
1
1
Size
1
Size
1
Size
2
2
Size
2
2