Start Up - Lennox icomfort Wi?Fi T Homeowner's Manual

Start up

In event of power failure If a power failure occurs,
when the power comes back on, the thermostat will reboot
and when complete, the HOME screen will return.
What the Home screen tells you...
After the thermostat and the
system has been fully con-
nected and powered on, the
icomfort Wi−Fit thermo-
stat's Home screen is dis-
played. Figure 1 shows a
display and describes what
the thermostat is telling you.
Note that set to heat or
cool communicates that the
system is operating in
manual mode; if it were in
program mode, the heat or
cool button would read
summer program is on (or
other named program).
Other information...
Until and unless the indoor temperature is at or between
the two settings (70 to 75 degrees in this example), the system
should run until it does measure within that temperature range.
The Wi−Fi indicator is (not
connected with your wireless network router.
Away mode sets the thermostat for energy saving while you are gone
for an extended period of time. In this mode, the system will only
come on if indoor temperature falls below 62 degrees (for heating) or
if indoor temperature rises above 85 degrees (for cooling).
heat−to setting cool−to setting
indoor
temperature indoor temperature
indoor
humidity
(if feature
is
turned on)
indoor humidity is 41%
system status
system is cooling
9:39 am January 23, 2012
online time, month, day, year
Figure 1. Home screen (typical)
), therefore, the thermostat is
What you can do from the Home screen...
Typically, what every homeowner wants from an air
(if feature is turned on)
system mode
outdoor temperature
outdoor
set temp temperature
80
75 heat
or
cool
cool−to
70
fan is
AUTO
fan is fan is
press to go
heat to
AUTO OFF
dashboard
use arrows
to change
temperature
?
service alerts are present
Adjusting the humidity, even if no physical humidifier or
dehumidifier is present, may also be available, provided the
installer has implemented the feature during setup.
icomfort Wi−Fit 7−Day Programmable Communicating Thermostat
Page 3
conditioning system is to be able to control that
system using a convenient device to
adjust heating, cooling, and the
level of humidity in the home.
From this screen you may:
away
mode
− adjust temperature
settings
− access menus to change
the program mode
− change how the
to user
fan operates
− access the dashboard"
fan is set
(fig. 3) by pressing
to AUTO
− access and view active
service alerts by pressing
the icon
− access help screen by
pressing the ?" icon.
Adjusting the temperature and changing the
system mode of operation is described fully
beginning on Page 14.
See Page 16 for details on humidity control.