Installing The Baystack 350T Switch; Surface Mounting - Bay Networks BayStack350T User Manual

Installing the BayStack 350T Switch

This section explains how to install, power up, and verify the operation of the
BayStack 350T switch. Before you begin these procedures, read and follow the
instructions in
Warning: To avoid bodily injury from hazardous electrical current, do not
connect the power cord until instructed to do so.
The BayStack 350T switch can be installed in any of the following locations:
•
•

Surface Mounting

The BayStack 350T switch can be surface mounted onto any appropriate surface
that can safely support the weight of the switch and attached cables, as long as
there is adequate space around the unit for ventilation and access to cable
connectors. Mounting brackets supplied with the switch allow you to secure the
BayStack 350T switch to the installation location.
Note: In most cases it is not necessary to secure the BayStack 350T switch
onto a tabletop or shelf. However, if conditions warrant securing the switch,
such as when installing the switch at locations that are subject to heavy traffic
or at overhead locations, you can secure the BayStack 350T switch with two
mounting brackets (supplied).
893-00992-A
"Site Preparation" on
Surface mount
— Tabletop or shelf (secured or unsecured)
— Wall mount
Rack mount—19-inch equipment rack
page 2-3.
Installation
2-5