Reset To Default Settings - Bay Networks BayStack350T User Manual

Using the BayStack Model 350T 10/100 Autosense Switch

Reset to Default Settings

The Reset to Default Settings command allows you to reset the switch and replace
all configured switch parameters with factory default settings.
Caution: If you choose this command, all of your configured settings will be
replaced with factory default settings when you press [Enter].
For a list of factory default settings, refer to
Settings."
The Reset to Default command takes approximately five seconds to complete.
During this period, the switch initiates a self-test that comprises various
diagnostic routines and subtests. The results of the self-test are displayed briefly
in the BayStack 350T Self-Test screen (see
immediately by the CI screens.
BayStack Model 350T Self-Test
Self-test complete.
Figure 3-26.
Note: The BayStack 350T Self-Test screen remains displayed only if the
self-test detects a fatal error.
The switch LEDs also display various patterns that indicate subtests are in
progress.
3-50
ASIC addressing test
ASIC buffer RAM test
Physical layer test
Port internal loopback test ... Pass
Example of a Reset to Default command self-test result
screen
Appendix C, "Switch Default
Figure 3-26), and is followed
... Pass
... Pass
... Pass
893-00992-A