Task 9: Configure the Switch Type
You must configure the switch type using the information collected in
Task 1 before connecting the network cables to the WAN ports. To
configure the switch type:
1.
After the RAC boots, enter cli at the console monitor prompt. (If
you are configuring a 5399, connect to the slot the 5399 is
installed in using the Slot Selection menu before entering the cli
command.)
2.
Enter admin as follows:
annex: su
Password:
The default root password is the RAC's IP address.
Annex# admin
3.
Using the set wan command, enter the switch type. The example
below shows how you set the switch for AT9. Enter the switch
type from the telco information. (For more information about
switch types, refer to
Access Concentrators
admin: set wan=1 switch_type AT9
You may need to reset the appropriate port,
Annex subsystem or reboot the Annex for changes
to take effect.
This sets the switch type for interface 1 to AT9. To
specify WAN 2, enter wan=2; for both WANs, enter
wan=all
Quick-Start Guide for Remote Access Concentrators
Provisioning WAN Lines for Remote
.)
118352-A Rev. A
9