Configuration And Switch Management; Network Configuration - Bay Networks BayStack350T User Manual

Configuration and Switch Management
The BayStack 350T switch is shipped direct from the factory ready to operate in
any 10BASE-T or 100BASE-TX standard network. You can manage the switch
with Optivity
network management software; however, you must assign an IP network address
to the switch. You can set the BayStack 350T IP address by using the service port
or by using the BootP protocol resident in the BayStack 350T switch. For more
information about using the service port for manual configuration of the switch,
see Chapter 3, "Using the Console
Network Configuration
The BayStack 350T switch can be connected to workstations and personal
computers (PCs) either directly, through a hub, or through the creation of
virtual LANs (VLANs). This section shows three network examples using the
BayStack 350T switch in the following configurations:
•
•
•
893-00992-A
network management software, or with any generic SNMP-based
®
Desktop connections for power workgroups
Desktop connections for power workgroups and shared media hub
Virtual LAN workgroups
Interface."
Getting Started
1-7