Introduction For The Main Device; Led Indication Light; Auto-Detect Protecting System; Pump W/Ballast For The Static Diving System - THUNDER TIGER Neptune SB-1 Instruction Manual

Submarine kit & sc
Table of Contents

Advertisement

INTRODUCTION FOR THE MAIN
DEVICE

LED INDICATION LIGHT

On the main control PCB unit, there are 3 LED lights are designed to show the current status of the Submarine.
You can watch the light from the right side 1st hull window. Please refer the following chart to get the light
information.
Light Sign
SB-1 Status
Yellow Light On--
(Y)
Water Pump On
(G)
Ballast Bag Filled
(R)
Diving
Green Light On—
(Y)
Water Pump On
(G)
Ballast Bag emptied
(R)
Surface

AUTO-DETECT PROTECTING SYSTEM

Combined with a auto-detect protecting system on the main PCB control board, if the system detects low battery
power, low transmission signal, leakage(water inside hull), then the roll pump will auto start to flood the water
out of the ballast tank to make the submarine float back to the surface. In the same time, the Red LED light will
turn to flash.

PUMP W/BALLAST FOR THE STATIC DIVING SYSTEM

Base on the Archimedes principle—principle that states a body immersed in a fluid is buoyed up by a force equal
to the weight of the displaced fluid. The principle applies to both floating and submerged bodies.
So base on this principle, equipped with a roll pump with ballast tank device in the inner hull, through the pump
operating system to draw or drain the water into or out of the ballast tank to change the weight of the submarine.
With suitable design of the volume and weight, then it is easy to operate the SB-1 submarine diving or floating
and even static stay under the water. So we call this the static diving system just like the real submarine.
The buoyancy of an object depends, therefore, only upon two factors: the object's volume, and the density of
the surrounding fluid. So when you choose the diffierence water(with diffierence density) to play, you have to re-
adjust the weight unit to make the submarine can be diving and floating smoothly and quickly. Normally, it need
take about 20~30seconds from floating to diving.
Light Sign
SB-1 Status
Red Light On (Continuous)
(Y)
Normal Operating
(G)
Tx signal lost
(R)
Red Light Flash
(Y)
Low Battery
(G)
(R)
Water inside Hull

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5220-k5220-f

Table of Contents