Table of Contents
Advertisement
INTRODUCTION
Congratulations on your purchase of the Thunder Tiger NEPTUNE SB-1 submarine. The NEPTUNE SB-1 submarine
st
is the 1
underwater R/C model by Thunder Tiger. Equipped with high technology operating equipment in the inner
hull tube, covered by the brilliantly yellow color outer hull, the NEPTUNE SB-1 will let you enjoy the otherwise hidden,
underwater world.
Adopting a static diving system, operating the Neptune is just like the real thing. The system is driven by a ballast
tank that with a pump &motor unit. Start the pump to induct the water into the ballast tank. Control the amount of
water in the ballast tank, the submarine can dive from the surface and stay underwater in static. Using the propulsion
power unit and full elevator and rudder control, you can drive the submarine graceful sailing underwater. Install a
digital camera (optional) and you can watch the amazing underwater scenes.
Equipped with a auto-detect protecting system, if the system detects low battery power, low transmission signal,
leakage, then the roll pump will auto start to flood the water out of the ballast tank to make the submarine float
back to the surface.
NEPTUNE SB-1 submarine, will bring you to experience the mystery world under water!
INDEX
1
INTRODUCTION
IMPORTANT NOTES & WARNING
ITEMS & TOOLS REQUIREMENT
3
ASSEMBLY SECTION
1. FRONT FLANGE UNIT ASSEMBLY
1.1 FRONT FLANGE
1.2 POWER DISTRIBUTION UNIT
1.3 COMPLETE FRONT FLANGE UNIT ASSEMBLY
2. REAR FLANGE UNIT ASSEMBLY
2.1 REAR FLANGE
2.2 SERVO UNIT
2.3 COMPLETE REAR FLANGE UNIT ASSEMBLY
3. OUTER FRAME ASSEMBLY
3.1 FRONT ELEVATOR BRACKET
3.2 OUTER RING FRAME
3.3 BOTTOM PLATE
3.4 BRACKET INSTALLATION
3.5 LINKAGE ROD
4. INNER STRUCTURE ASSEMBLY
4.1 1
ST
INNER FRAME W/MAIN CONTROL PCB
4.2 2
ND
INNER FRAME W/RECEIVER
4.3 4
FRAME W/PUMP UNIT
TH
TH
4.4 5
FRAME W/SPEED CONTROLLER
4.5 COMPLETE INNER FRAMES ASSEMBLY
5. PROPULSION SYSTEM W/REAR COVER ASSEMBLY
2
2
6. COMPLETE HULL STRUCTURE ASSEMBLY
4
7
7. EXTERNAL BODY ASSEMBLY
9
CONFIGURATION
RADIO CONTROL VS SUBMARINE MOVEMENT
INTRODUCTION FOR THE MAIN DEVICE
OPERATING
10
MAINTENANCE AND PERIODICAL CHECK UP
SERVICE
5.1 MOTOR W/DRIVE CUP
5.2 MOTOR MOUNTING W/DRIVE SHAFT
5.3 MOTOR UNIT W/ REAR COVER PLATE
6.1 OUTER FRAME W/ SPACER TUBES
6.2 MAIN HULL TUBE W/INNER STRUCTURE & OUTER FRAME
6.3 FRONT & REAR FLANGE CAP ASSEMBLY
6.4 FRONT & REAR COVER PLATE ASSEMBLY
6.5 WEIGHT INSTALLATION
7.1 FRONT CABIN ASSEMBLY
7.2 REAR CONE UNIT ASSEMBLY
7.3 LEFT & RIGHT SIDE HULL
7.4 COMPLETE MODEL ASSEMBLY
21
24
27
14
15
16
22
23
27
Hide quick links:
Advertisement
Table of Contents
