Removing The Front Bezel - Raymarine C-series Installation Manual

87020-3.book Page 25 Tuesday, March 7, 2006 11:02 AM
Chapter 3: Installation
2. Place the bezel over the front of the C-Series Display, ensuring that locking lugs
located at the bottom edge of the bezel are latched into position.
3. Ensure that the control buttons pass through their respective openings.
4. Apply firm but even pressure to the bezel along the:
• Outer edges - work from the sides upwards and then along the top edge, to
• Inner edges - particularly along the chart card door edge, to ensure that the
5. Check that all control buttons are free to operate. It is suggested that you use your
thumb or forefinger in a circular motion to do this.

Removing the front bezel

To remove the front bezel:
1. To prevent damaging your dash or placing undue strain on the trunnion bracket:
• Trunnion mounted unit - unscrew and remove display from the mounting.
• Flush mounted - protect your dash and proceed with caution.
2. Place a flat-bladed screwdriver in the aperture at the top right of the bezel and gen-
tly twist it to release the top clips.
ensure that it clips securely into position.
bezel sits flat.
25
D7214_1