Sending Data To A Server (Scan To Ftp); Scan To Ftp - Konica Minolta bizhub C550 User Manual

5
5.5

Sending data to a server (Scan to FTP)

Scan to FTP

The Scan to FTP operation can be used in a network environment that contains an FTP server. The scan data
can be sent to a folder specified on an FTP server on the network.
This is suitable for transmitting large-sized data, such as high-resolution data.
Destinations can be selected using any of the following methods. In addition, the methods can be combined,
for example, by selecting a recipient from a group destination, then adding other destinations through direct
input.
Transmission may not be possible if the document name is too long according to the destination server
conditions. Since the scanning settings are used, consult your network administrator when specifying the
document name.
Destinations can be selected for Scan to FTP operations using any of the following methods. For details, refer
to the corresponding section.
Selection method
Selecting from the address book
Entering addresses directly
Selecting a group destination
Selecting a destination that was searched for
!
Detail
If a mail server is available in the network environment, the e-mail notification function can be used to
send notifications that jobs are completed. For details on the e-mail notification function, refer to
"E-Mail setting" on page 5-85.
If a proxy server is available in the network environment, an FTP server on the Internet can be accessed
through the proxy server.
5-30
Network Scanner Operations
Page reference
p. 5-31
p. 5-33
p. 5-18
p. 5-21
bizhub C650/C550/C451 (FE3)