Exterior Flue Termination Locations - Regency GEM54-NG Owner's Manual

Gem54 series gas fireplace
Hide thumbs Also See for GEM54-NG:
Table of Contents

Advertisement

according to AS5601-2004 (AGA gas installation code) or NZS 5262 (New Zealand)
a
b
c
d
e
f
g
h
j
k
(I) For mechanical air inlets, including spa blowers, the clearance 'j' and 'k' shall be 1500 mm in all cases.
(II) All distances shall be measured vertically or horizontally along the wall to a point in line with the nearest par to of the terminal.
(III) Prohibited area below electricity meter or fuse box extends to ground level.
(IV) A fl ue terminal of this type shall not be located under a roofed area unless the roofed area is fully open on at least two sides and a free fl ow of
air at the appliance is achieved.
Regency Gemfi re™ Gas Fireplace

EXTERIOR FLUE TERMINATION LOCATIONS

Minimum clearances required for balanced fl ue terminals or
the fl ue terminals of outdoor appliances
and local authorities having jurisdiction.
Below eaves, balconies or other projections:
- Appliances up to 50 MJ/h input
- Appliances over 50 MJ/h input
From the ground or above a balcony
From a return wall or external corner
From a gas meter (M)
From an electricity meter or fuse box (P)
From a drain or soil pipe
Horizontal from any building structure (unless appliance is approved
for closer installation) or obstruction facing a terminal
From any other fl ue terminal, cowl or combustion air intake
Horizontally from an openable window, door, or non-mechanical air inlet, or
any other opening into a building, with the exception of sub-fl oor ventilation
(see also Note (I)):
- Appliances up to 150 MJ/h input
- Appliances over 150 MJ/h input
Vertically below an openable window, door, or non-mechanical air inlet,
or any other opening into a building, with the exception of sub-fl oor ventilation
(see also Note (I)): see table below
Space Heaters
Up to 50 MJ/h
input
150
Clearance 'k' in mm
All Other Appliances
Up to 50 MJ/h
Over 50 MJ/h input
to 150 MJ/h input
500
1000
INSTALLATION
Minimum Clearance (mm)
300
500
300
500
1000
500
150
500
500
500
1500
Over 150 MJ/h
input
1500
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gem54-ulpgGem54-lpgGem54

Table of Contents