Vent Restrictor Position - Regency GEM54-NG Owner's Manual

INSTALLATION
Vent restriction is required for certain venting installations, see the diagrams in the "Venting
Arrangements" section to determine if they are required for your installation.
The Vent Restrictor plate is located on the inside top of the fi rebox.
To set the vent restriction as indicated in the venting arrangements diagrams, refer to the following instructions;
1) Remove the glass door.
2) Remove the screws that hold the vent restrictor plate in place.
3) Adjust the vent restrictor plate to the required vent restrictor position as per the diagrams shown.
4) Once the vent restrictor plate is in the required position, secure with screws.
ent Restrictor Settings for Gem54-NG
V
SET 1
THIS HOLE SETS THE
VENT RESTRICTOR
AT 108mm
SET 2
THIS HOLE SETS THE
VENT RESTRICTOR
AT 76mm
SET 3
THIS HOLE SETS THE
VENT RESTRICTOR
AT 51mm
14

VENT RESTRICTOR POSITION

108mm
Vent Restrictor Set 1
76mm
Vent Restrictor Set 2
51mm
Vent Restrictor Set 3
ent Restrictor Settings for Gem54-LP
V
SET 1
THIS HOLE SETS THE
VENT RESTRICTOR
AT 108mm
SET 3
THIS HOLE SETS THE
VENT RESTRICTOR
AT 51mm
SET 4
THIS HOLE SETS THE
VENT RESTRICTOR
AT 25mm
Gem54-ULPG
Regency Gemfi re™ Gas Fireplace