Safety Instructions / Operation
Original ancillaries / and
accessories
J
Only use accessories and tools that are specified
in the operating instructions. The use of tools
and accessories other than those recommended
in the operating instructions could lead to an
increased risk of personal injury for you.
Any questions?
J
You may begin the work once you have famil-
iarised yourself with the instructions, functions
and handling of the appliance. The safest work
is possible by heeding all information and
instructions of the manufacturer.
Operation
Operation
Take note of the mains voltage! The voltage must
agree with the information on the type plate of the
appliance (appliances that are designated as 230 V
can also be connected to 220 V).
Switching On and Off
Switching on intermittent function:
j
Press the ON / OFF switch
Switching off intermittent function:
j
Release the ON / OFF switch
Switching on continuous operation :
j
Press the ON / OFF switch
and press the locking button
Switching off continuous operation:
j
Press the ON / OFF switch
again.
10 GB/IE
You can set the desired oscillation speed as
needed with the oscillation speed selector
The required oscillation speed depends on the
material being worked and can be determined
through practical tests.
m Warning! Before performing work on the
appliance, always disconnect the power.
Note: Before attaching a new sanding pad
remove dust and dirt from the sanding plate
1. Open the two tensioning levers
2. Slide the sanding pad
3. Do the same at the other end. Make certain
4. Important! To ensure that vacuuming of dust
Various materials require different grit values. You
can read which grit value is best suited for which
1
.
work in our recommendations under "Tips and tricks".
1
.
, hold it pressed
m Warning! Fire hazard! A risk of fire exists
1
when working with electrical appliances that have
2
.
a dust collection box
vacuum cleaner via an external suction adapter!
then release it
Under unfavourable conditions, such as flying
1
sparks, grinding of metal or metal remnants in
wood, the wood dust in the dust sack (or in the dust
bag of a vacuum cleaner) can ignite. This can
Setting the oscillation speed
Attaching a sanding pad
them up to clamp in a new sanding pad
when switching the sanding pads
use with different material.
clamping bar
above the sanding plate
6
and clamp it tightly by pressing the tensioning
lever
back down.
7
that the sanding pad
9
sanding plate
. See also Fig. B and C.
8
through the sanding plate
the holes in the sanding pad
sanding plate
must match up.
8
Vacuuming dust
or can be attached to a
4
.
10
,
9
8
.
by pushing
7
or
9
for the
9
at one end under the
9
8
rests firmly against the
is guaranteed,
8
and the
9