Fingerprint Reader Board - HP EliteBook 820 G1 Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board (includes bracket and cable)
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4. Remove the service cover (see
components:
a.
Battery (see
b.
Hard drive (see
c.
Keyboard (see
d.
Top cover (see
Remove the fingerprint reader board:
1. Turn the top cover upside down with the front toward you.
2. Detach the fingerprint reader board cable (1) from the top cover. (The fingerprint reader board
cable is attached to the top cover with double-sided adhesive.)
3.
Remove the three Phillips PM2.0×2.5 screws that secure the fingerprint reader board and bracket
to the top cover.
4. Remove the fingerprint reader board bracket (3).
ENWW
Service cover on page
Battery on page 73)
Hard drive on page
Keyboard on page 85)
Top cover on page 94)
71), and then remove the following
75)
Component replacement procedures
Spare part number
730554-001
121