Touchpad - HP EliteBook 820 G1 Maintenance And Service Manual

TouchPad

Description
TouchPad (includes cable)
Before removing the TouchPad, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4. Remove the service cover (see
components:
a.
Battery (see
b.
Hard drive (see
c.
Keyboard (see
d.
Top cover (see
Remove the TouchPad:
1. Turn the top cover upside down with the front toward you.
2. Release the ZIF connector (1) to which the TouchPad cable is attached, and then disconnect the
TouchPad cable from the card reader board.
3. Remove the two Philllips PM2.0×3.25 screws (2) that secure the TouchPad to the top cover.
ENWW
Service cover on page
Battery on page 73)
Hard drive on page
Keyboard on page 85)
Top cover on page 94)
71), and then remove the following
75)
Component replacement procedures
Spare part number
730549-001
107