ZyXEL Communications ZyWALL 1100 User Manual page 139

heading cell again to reverse the sort order. The Web Configurator saves the filter settings if you
leave the View Log screen and return to it later.
Figure 120 Monitor > Log > View Log
The following table describes the labels in this screen.
Table 64 Monitor > Log > View Log
LABEL
Show Filter
Display
Email Log Now
Refresh
Clear Log
#
Time
Priority
Category
Message
Source
Destination
Chapter 6 Monitor
DESCRIPTION
Click this button to show or hide the filter settings.
If the filter settings are hidden, the Display, Email Log Now, Refresh, and Clear
Log fields are available.
If the filter settings are shown, the Display, Priority, Source Address,
Destination Address, Service, Keyword, and Search fields are available.
Select the category of log message(s) you want to view. You can also view All Logs
at one time, or you can view the Debug Log.
Click this button to send log message(s) to the Active e-mail address(es) specified
in the Send Log To field on the Log Settings page.
Click this button to update the information in the screen.
Click this button to clear the whole log, regardless of what is currently displayed on
the screen.
This field is a sequential value, and it is not associated with a specific log message.
This field displays the time the log message was recorded.
This displays when you show the filter. Select the priority of log messages to
display. The log displays the log messages with this priority or higher. Choices are:
any, emerg, alert, crit, error, warn, notice, and info, from highest priority to
lowest priority. This field is read-only if the Category is Debug Log.
This field displays the log that generated the log message. It is the same value used
in the Display and (other) Category fields.
This field displays the reason the log message was generated. The text "[count=x]",
where x is a number, appears at the end of the Message field if log consolidation is
turned on and multiple entries were aggregated to generate into this one.
This displays when you show the filter. Type the source IP address of the incoming
packet that generated the log message. Do not include the port in this filter.
This displays when you show the filter. Type the IP address of the destination of the
incoming packet when the log message was generated. Do not include the port in
this filter.
ZyWALL/USG Series User's Guide
139