Page 3
Device overview 1 VOL -: Decreases the volume 2 On/Off switch: • Long press (longer than 3 seconds): Switches the Lucca on or off. • Short press: Opens the main menu. 3 VOL +: Increases the volume 4 Display (Touchscreen): All entries and the control of Lucca are carried out in a simple and intuitive way by touching the buttons shown on the display.
Contents Device overview ........2 Locking/unlocking the Lucca ....13 Changing the PIN ......13 Safety notes ........6 Navigation ........14 Use as directed ........6 Safety notes for navigation ......6 General notes about the navigation ..14 Safety notes for handling the Lucca ..6 Starting the navigation ......14 Notes for handling the CD/DVD ....6 Entering a destination address ....14 Disposal notes ........7...
Page 5
Contents Save a tour .........23 Browse ...........32 Delete a tour ........23 Equalizer ........32 Show in map ........23 Showing image fi les ......32 Exiting the menu .........23 Slide show ........33 Additional functions ......33 Specifying route options ....24 Browse ...........33 Route guidance........25 Exiting multimedia .......33 Start route guidance ......25 Removing the memory card ....33...
Safety notes Safety notes Safety notes for handling the Lucca For your personal benefi t, carefully read the fol- Caution: lowing safety notes and warnings before operat- ing your Lucca for the fi rst time. Protect the device against moisture since it is not waterproof and not splashproof.
TMC line antenna • Operating instructions (short version) • Backup DVD Note: We recommend the use of original Blaupunkt accessories. Protective screen fi lm Prior to the initial use, carefully remove the pro- tective fi lm from the display. Charging the battery The built-in battery allows for operating the Luc- ca battery-operated for up to 3 hours.
Initial startup of the Lucca | Installation in the vehicle the battery is no longer charge at an ambi- Installation in the vehicle ent temperature above 45 °C. For temporary installation in a vehicle, the Lucca features a suction cup holder with a suction cup to Switching on the Lucca attach it to the windshield.
Installation in the vehicle | Switching on/off Removing the Lucca Switching on/off Hold the Lucca in both hands and press The On/Off switch is used to switch the Lucca on against the clamp with your thumbs. and off and to open the main menu. Pull the Lucca up and out of the clamp.
Operating the menus Operating the menus Lists You can frequently display lists form which you can Main menu select an entry (e.g. a destination). For example, if you do not enter the complete name of a location, The main menu provides access to all applications a list with possible results is displayed.
GPS info GPS info The GPS Info menu contains information about your current position and your current speed. In addition, you can view the strength of the GPS signals. GPS mode of operation GPS is based on a total of 24 satellites that are orbiting the earth and sending out signals.
PUK for the 3rd time, your device without considering daylight savings time. is permanently blocked and the Lucca must be returned via the Blaupunkt service. Touch the symbol to activate (check mark) or deactivate (no check mark) daylight savings time.
Lucca if you should forget the PIN. Follow the instructions and enter a self-se- lected PUK. Touch the OK button. To secure your PUK: Register under http://puk.blaupunkt.com and follow the instructions. Locking/unlocking the Lucca Prerequisite: • You confi gured the PIN query.
Navigation From the map, you can directly change to the Navigation navigation menu or the Map Settings menu. Touch the symbol. General notes about the navigation The Navigation menu is displayed. Caution: Do not operate the Lucca while driving to protect yourself and others against accidents! View the display only if you are in a safe travel situ- ation!
Navigation Touch the symbol and enter the city Using the home address as or postal code. destination If your home address is saved, you can quickly Touch the symbol and enter the part navigate home from any location. The stored ad- of town.
Navigation Touch the symbol. Copying one of the last destinations The Points of Interest menu is dis- Touch the symbol in the Navigation played. menu. You can now select where the desired point of The Destination Input menu is dis- interest is located.
Navigation – Displaying a destination on the – Calculating a route (ch. "Calcu- map (ch. "Working with the lating a route") map") – Saving a destination as favourite Selecting a point of interest at a specifi c (ch. "Managing destinations") location In the Points Of Interest menu, touch –...
Navigation – Displaying a destination on the Selecting a supraregional point of interest map (ch. "Working with the If a point of interest cannot be precisely assigned map") to a location, e.g. an airport, a motorways exit and a mountain pass, you can enter it as a suprar- egional point of interest.
Navigation | Storing the position Copying a destination from the map Storing the position Touch the symbol in the Navigation You can store your current position and later use menu. it as a destination. The Destination Input menu is dis- Touch the symbol in the main menu played.
Managing destinations Touch the button to call up the add- Managing destinations on menu. Two lists are available in which individual destina- Touch the symbol. tions are saved: The keyboard is displayed. • In the Favourites • In the Last Destinations list Enter a name for the destination and touch Destinations from the Favourites can be re- named.
Managing destinations | Calculating a route Touch the symbol. Calculating a route A confi rmation is displayed. After the destination entry, you can calculate the route to obtain travel time and distance. After the Touch Yes to delete the destination. route calculation, you have the option to start - or - the route guidance or to display the route on the...
Demo | Tour planning Demo Tour planning In the demo, you can enter a route and travel it. You can also perform the tour planning without The same information is displayed and voice in- GPS reception, e.g. at home at your convenience, structions are output as during a route guidance and gain an overview of your route for your vaca- (ch.
Tour planning Tour planning from favorites Save a tour Touch the symbol in the Navigation Touch the symbol in the add-on menu. menu. The Favourites menu is displayed. The keyboard is displayed. Touch the destination to be adopted as the Enter a name for the route and touch OK.
Specifying route options Touch the symbol to allow (check Specifying route options mark) or disallow (no check mark) Touch the symbol in the map view. toll roads. The Navigation menu is displayed. Touch the symbol to allow (check mark) or disallow (no check mark) Touch the symbol.
Route guidance Route guidance Disturbed GPS reception In the map, the symbol indicates that no Start route guidance suffi cient GPS signal is being received. If you start route guidance at this point, Lucca calcu- Touch the Start Route Guidance button. lates the route based on the last known position.
Working with the map Enter a name for the destination and touch Working with the map The destination is stored in the Favourites Showing a map under the name entered. (Ch. "Managing des- Touch the symbol in the main menu tinations") of the Lucca.
Working with the map | Voice output during route guidance – Touch the symbol to adjust a tol- Voice output during route erance value for the speed warn- guidance ing. A warning occurs only if the The Lucca supports the route guidance with voice- tolerance value is exceeded.
Map display during route guidance Map display during route Voice output is activated. guidance Voice output is deactivated (muted). During a navigation, the map display shows differ- Touching the symbol reactivates the voice ent navigation tools and route information. output. Caution Route information The information on the digital road maps may no...
Additional functions during the route guidance Additional functions during the The symbol identifi es the blocking. The blocked segment is marked in red. route guidance To cancel the blocking: Prerequisite: In the add-on menu, touch the sym- • Route guidance bol again (the check mark indicates - or - that a blocking has been entered).
Additional functions during the route guidance | TMC function Display route list TMC function The route list can be displayed to gain an overview The Traffi c Message Channel (TMC) supplies your of the route. Lucca with traffi c reports that are broadcast by the radio stations with the RDS (Radio Data Sys- Touch the symbol in the add-on tem) signal.
TMC function | Multimedia Searching for TMC stations Multimedia The Lucca automatically sets the next receivable You can play music and image fi les in the Multime- TMC station. You can also search for a TMC station dia menu. of your choice. Inserting a memory card Touch the button in the TMC Messag- es menu.
Multimedia ID3 texts represent additional information, Press the VOL - or VOL + button to adjust the e.g. album, artist and track, which music volume. tracks in MP3 format may contain. Touch the symbol to play the fi rst track of the next directory. Browse The music list displays the music data and direc- Touch the symbol repeatedly to play...
Multimedia • Larger images require longer loading times. Touch the symbol to rotate (check The Lucca can display images up to a size of mark) or not to rotate (no check 6 megapixel. mark) all images. Browse The image list displays the image fi les and direc- tories in the order in which they are located on the memory card.
Data transfer Touch the symbol. Data transfer The Navigation menu is displayed. You can make additional road maps and media data (music fi les and image fi les) available to the Touch the symbol. Lucca via a memory card. The Settings menu is displayed. Preparing the memory card Touch the symbol.
Confi guring Lucca Confi guring Lucca Touch the Brightness Day button to adjust the display brightness for day mode. The Lucca features two menus in which you can Touch the Brightness Night button to adjust perform settings: the display brightness for night mode. •...
(check mark) or The PIN can be changed at any time. Register un- off (no check mark). der http://puk.blaupunkt.de to securely store If you activated the demo mode, the Lucca your PUK. switches to demo mode after 5 minutes of For further details, read the chapter "Performing...
Blaupunkt offers software downloads at regu- If you are using your own POIs (points of interest), lar intervals. They can be found on the Blaupunkt the Lucca can bring it to your attention in due time Internet site www.blaupunkt.com.
In some countries Blaupunkt offers a specifi c re- 122 x 94 x 20 mm pair service including a pick-up service. In case your Lucca has to be sent to Blaupunkt for Weight service you can order a pick-up service for your approx.
Troubleshooting table Troubleshooting table Problem Cause Solution The Lucca does not work or The operating system of the Press and hold the On/Off does not work correctly. Lucca is overloaded. switch for longer than 14 sec- onds to perform a reset. The Lucca is restarted.
Page 40
(MMC). If problems occur with one memory card, try a memory card from a different manufacturer or with a different capacity. Due to continuing de- velopments, Blaupunkt cannot guarantee proper functioning of memory cards of different man- ufacturers and types.
Page 41
Troubleshooting table Problem Cause Solution The multimedia application The media fi les on the memory Copy music fi les using the for- does not play some or all media card are stored in the wrong fi le mats MP3 and WMA for music, fi...