Related Manuals for Blaupunkt TRAVELPILOT LUCCA 3.3 EE
Summary of Contents for Blaupunkt TRAVELPILOT LUCCA 3.3 EE
- Page 1 Mobile Nav igation TravelPilot Lucca 3.3 EE Operating and installation instructions Detailed version...
-
Page 2: Overview
Overview Overview The Lucca features the following buttons next to its screen: 1 On/Off: • Press for more than 3 seconds to turn the Lucca On or Off • Press briefl y to turn the screen On or Off. (Economy mode) 2 MENU button : •... -
Page 3: Table Of Contents
Contents Overview ...2 Safety instructions ...5 Navigation safety instructions ... 5 Safety instructions for handling the Lucca 5 Using the CD/DVD ... 5 Using the Lucca for the fi rst time ...6 Lucca scope of delivery ... 6 Protective touch screen foil ... 6 Turning the Lucca on ... - Page 4 Contents Selecting route parameters ...22 Route guidance ...23 GPS reception problems ... 24 End Route Guidance ... 24 Arriving at your destination ... 24 Starting route planning without the use of GPS signals ...25 Using the map ...25 Show map ... 25 Operating the map ...
-
Page 5: Safety Instructions
About these instructions Safety instructions Please read the following safety instructions and warnings carefully before using the Lucca for the fi rst time. Navigation safety instructions Caution: Never operate the Lucca while driving as this could lead to accidents affecting yourself and others! Only ever look at the screen when there is absolutely no doubt that it is safe to do so... -
Page 6: Using The Lucca For The Fi Rst Time
Second car kit • Van/SUV suction cup holder • Vent mount We recommend use of original Blaupunkt accessories only. Protective touch screen foil Remove the protective foil from the screen before using the Lucca for the fi rst time. Turning the Lucca on The Lucca can be turned on/off using the On/Off button. -
Page 7: Charging The Battery
The battery can be recharged using either the supplied charger cable for the cigarette lighter or the optionally available charger. • Only use Blaupunkt-approved chargers. Please contact your Blaupunkt dealer for more information on Blaupunkt- approved chargers. • Never dispose of defective battery chargers domestic “designated”... -
Page 8: Connecting The Lucca To The Suction Cup Holder
Installing the Lucca into a car Connecting the Lucca to the suction cup holder The suction cup holder is equipped with a guide for attaching the Lucca. ➜ Carefully engage the guide on the Lucca with the bar on the suction cup holder. Removing the Lucca ➜... -
Page 9: The Menu Button
The MENU button The MENU button can be used to open the Quick Settings (press briefl y) or to go back to the Main Menu (press for more than 3 seconds), from where the Navigation, Music Player or Picture Viewer applications can be started. -
Page 10: Using The Navigation Menus
Using the navigation menus Using the navigation menus Onscreen keyboard The Lucca features a soft (onscreen) keyboard that will be shown on the touch screen when required to enter text. Using your fi ngers, tap the relevant keys on this keyboard to enter text or data. -
Page 11: Information On Gpss
Information on GPSs You can view the GPS’s status in the GPS Info menu. This menu can furthermore be used to view GPS-derived information, such as your current position and speed. The GPS Info menu can be opened in the Navigation menu. -
Page 12: Navigation
Navigation Navigation General navigation information Use of the Lucca is at your own risk! Caution: Never operate the Lucca while driving as this could lead to accidents affecting yourself and others! Only ever look at the screen when there is absolutely no doubt that it is safe to do so as regards the traffi... -
Page 13: Viewing Gps Info
Please read the chapter “Basic settings” for more information. Viewing GPS info ➜ Press the GPS info button to view GPS information. Please read the chapter “GPS” for more information on this. Close menu ➜ Press the Back button in the Navigation menu to return to the main menu. -
Page 14: Entering A Destination
Navigation Entering a destination Lucca will always guide you through the destination entering process by: asking for a destination town, street and house number. Once entered, destinations are automatically saved so that they can be repeatedly and quickly accessed again at a later time. You can only enter destinations (countries, towns, streets, house numbers) that are included on the cartographic material. -
Page 15: Selecting A Destination From The History
➜ Enter a street name and press Done. The onscreen keyboard will now come up to enable you to enter the number of the house you would like to navigate to. You can now enter a house number or navigate to an intersection (junction): ➜... -
Page 16: Selecting A Point Of Interest (Poi)
Navigation ➜ Press on either the N/S or E/W button to change between North (latitude) or East and West (longitude). ➜ Now enter the coordinate in its relevant unit of measure. The “degree” button will automatically change to the next unit of measure etc. once used. -
Page 17: Activate/Deactivate Pois
➜ Press on an icon of your choice to select a POI sub-category, such as Shopping Center. You will now be shown a list of POI’s matching your search information on their distance. You can now either select one of the POIs from the list or look for one yourself: ➜... -
Page 18: Organise Favourites
Navigation ➜ Select the entry you want to navigate to from the list and press it. You will now be shown additional information on the selected destination. ➜ Press Done. The Lucca will now display the map and plan the route. Organise Favourites You can organise you Favourites: •... -
Page 19: Minimising/Maximising The Map
Minimising/maximising the map You can minimise or maximise the map to view the area your destination is located in on the map. ➜ Use the Plus/Minus buttons to minimise and maximise the view of the map. Entering Way Points You can use the Edit Way Points menu to enter Way Points on the map. -
Page 20: Deleting A Way Point From The Map
Navigation If the Lucca is receiving GPS signals, it will automatically use its current position as the starting point for any route. – Route To: To use this place as a destination – Add Via: To use this place as an intermediate destination –... -
Page 21: Deleting A Destination (Favourites Only)
Administrating destinations You will now be shown an input mask. ➜ Enter a new name for the destination. ➜ Press OK. The destination will now be renamed. Deleting a destination (Favourites only) ➜ Press the Navigation button in the main menu. The Navigation menu opens. -
Page 22: Selecting Route Parameters
Pins ➜ Press the Advanced Settings button. Advanced opens. ➜ Press the User data management button. The User data management menu opens. ➜ Press Remove Pins to delete all of the pins shown on the map. You will now be shown a confi rmation prompt. -
Page 23: Route Guidance
Selecting route parameters – Ferries – Permit needed, e.g. roads accessible only to permit holders and emergency vehicles – Motorways – U-turns (making a U-turn) – Toll Roads Some road types will be automatically excluded from use in route planning depending on the vehicle profi... -
Page 24: Gps Reception Problems
Route guidance When planning a route, the Lucca will always take the route parameters, which can be viewed and changed in the Route Parameters menu, into account. (Chap. “Selecting route parameters”) GPS reception problems If the GPS is unable to receive a signal once the destination has been entered, the cursor will be shown in grey. -
Page 25: Starting Route Planning Without The Use Of Gps Signals
Starting route planning without the use of GPS signals Starting route planning without the use of GPS signals If you do not have any GPS reception, you can still start route planning in order to gain an overview of the route. You can do so provided: •... -
Page 26: Change The Map's Orientation
Using the map Change the map’s orientation ➜ You can use the following buttons to change the map’s orientation to: – the direction you are driving in (default) – North – Overview mode Map is minimised and oriented North. Pressing points on the map When in map view, the screen features three touch-sensitive areas: ➜... -
Page 27: Map View During Route Guidance
Map view during route guidance During route guidance, the map view will feature a range of navigational aids and route information. Caution Please note that information displayed on the map might not always be fully up to date, such as in the case of emergency road works etc! The local traffi... -
Page 28: Changing Route Information
Map view during route guidance You will now be presented with the following buttons: – Daylight colour profi l: For selecting the colour settings used when viewing the map in daylight – Night colour profi l: For selecting the colour settings used when viewing the map in the night The daylight/night time settings can be changed manually or set to automatic. -
Page 29: Additional Navigation Functions
Additional navigation functions The features described in this chapter are only available once a route has been planned (with or without use of the GPS signals). (Chap. “Route planning” and chap. “Route planning without the use of GPS signals”) Adding/Deleting a Way Point You use the Edit Way Points menu to add/ delete Way Points. -
Page 30: Route Information
Additional navigation functions Route information The Route Information menu can be used to choose additional information on the route to be displayed on the map. The Route Information menu can also be used to open the Route Parameters menu. You can also view the Route Information menu by pressing on the route information shown on the map. -
Page 31: Track Logs
➜ Select the distance for which you want to block the route (starting from your current position). The Lucca will now plan the route anew and circumvent the blocked section of the route. If you want to remove the block placed on a section of the route, you have to end route guidance. -
Page 32: Route Recording Options
Additional navigation functions You will now be presented with the following buttons: – Colour on the map: To change the colour used for showing the route on the map – Rename: To name the route – Fit To Screen: To show the route on the map –... -
Page 33: Basic Settings
Basic settings The Settings menu can be used to change the Lucca’s settings and to view product information. ➜ Press on the Info … button to view additional information on the Lucca’s software. General settings ➜ Press the Navigation button. The Navigation menu opens. -
Page 34: Map Options
Basic settings You can select the tolerance either as a percentage value or kilometres per hour. ➜ Press on Fixed Value/Percentage to switch between the two settings. Map options You can use the Map Settings menu adjust Lucca’s settings. You can also use this menu to select to show/hide POIs and international and national street names on the map. -
Page 35: Languages And Units
Languages and units You can use the Language & Units menu to select your preferred menu and voice output language. You can also use this menu to change the time, date and distance displays. When selecting the language for the menus, the Navigation application will close and restart to load the new language settings. -
Page 36: Smart Zoom
Basic settings The Brightness menu opens. ➜ Slide the Set custom backlight value for daylight controller along the bar to adjust the brightness for day mode. ➜ Slide the Set custom backlight value at night controller along the bar to adjust the brightness for night mode. -
Page 37: Data Management
You can also use this menu to select the cursor on the map to be aligned with the relevant road you are travelling along or to show your actual position, e.g. when walking. If you selected “Pedestrian” under Vehicle Profi le in the route parameters, the cursor will automatically show your actual position. -
Page 38: Gps Operating Principle
GPS operating principle GPS operating principle The Global Positioning System (GPS) was developed by the American military in the 1970’s. GPS’s rely on a total of 24 satellites that are orbiting the earth and transmit signals. The GPS receiver uses the time delay between transmission and reception of these signals to calculate its distance to the individual satellites. -
Page 39: Music Player
Music Player You can also use the Lucca to playback audio fi les from a SD/MMC card. The Lucca recognises the following audio fi le formats: MP3, WMA and OGG. Audio content is played back either over the Lucca’s internal speaker or a set of headphones. -
Page 40: Picture Viewer
Picture Viewer Picture Viewer You can also use the Lucca to view images stored on a SD-/MMC card. Lucca recognises JPG, GIF and BMP format image fi les. The chapter “Using the SD/MMC card” contains information on how to use and prepare the card. -
Page 41: Uploading Cartographic Material
CD/DVD for reinstallation purposes. Updating the navigation software Blaupunkt regularly releases updates in order to make sure that your Lucca is always up to date. These updates can be downloaded from www.blaupunkt. com. Please follow Lucca’s instructions for downloading. Lucca software... -
Page 42: Technical Data
Blaupunkt offer repair and collection services in a number of European countries. In the event that you need to send your Lucca to Blaupunkt for servicing, you may be able to request collection using our online services. Please visit www.blaupunkt.com to fi nd out whether this service is available in your country. -
Page 43: Frequently Asked Questions /Faq
Frequently Asked Questions /FAQ Why does the Lucca need GPS reception? The Lucca needs GPS reception to determine its position. It receives information both on its location and direction of travel from the GPS satellites. This is what enables the Lucca to safely guide you to your destination. - Page 44 How long does it take to download data from the SD-/MMC into the Lucca’s memory? Around 15 minutes depending on the size of the data. Is it possible to play DRM protected WMA fi les on the Lucca? It is not possible to play Digital-Rights- Management protected WMA fi...
- Page 46 Ukraine (UA) http://www.blaupunkt.com © 2007 All rights reserved by Blaupunkt. This material may not be reproduced, copied or distributed for personal use. Please take also notice of the end user licence agreement for the software and the database on the enclosed CD/DVD.