Superior Gas Log Installation And Operation Instructions Manual page 9

HEARTH KIT ASSEMBLY AND
INSTALLATION
Kit Assembly - Single and Dual Flame
Only
1. Determine which side gas line will be
coming into fireplace.
2. Using a hammer and screw driver, remove
knockout plug from side of pan that cor-
responds to gas line (see Figure 6).
3. Unscrew burner inlet fitting from burner
manifold.
4. Place burner manifold in pan with thread-
ed opening facing open knockout plug.
5. Using thread sealant (resistant to the ac-
tion of propane/LP gas) on larger end of
fitting, screw burner inlet fitting through
hole and into burner manifold (see Fig-
ure 6). Tighten using a wrench. If using
propane/LP gas, see Propane/LP Gas
Conversion, page 11.
6. Using burner clamp, screw, and nut pro-
vided, assemble clamp to pan ("U" style
and triple burners only). This will hold
burner manifold in place.
7. If using optional GA9050A-1 kit, go to
Optional GA9050A-1 On/Off Safety
Valve/Pilot Kit , page 10, for installation
instructions. If using optional GA9150A
kit, follow instructions included with kit for
installation and operation.
126904-01A
INSTALLATION
Continued
www.SuperiorFireplaces.US.com
SINGLE-BURNER
Knockout
Plugs
Burner Pan
(Front)
DUAL-FLAME
Nut
Burner
Manifold
Knockout
Plugs
Burner Pan
(Front)
Figure 6 - Installing Burner
Burner Manifold
Burner Inlet
Fitting
Burner Clamp
Burner Inlet
Fitting
Screw
9