Cleaning And Maintenance - Superior Gas Log Installation And Operation Instructions Manual

Note: You may be running this log set
for the first time after hooking up to gas
supply. If so, the control knob may need
to be pressed in for 30 seconds. This will
allow air to bleed from the gas system.
• If control knob does not pop up when
released, contact a qualified service
person or gas supplier for repairs.
6. With control knob pressed in, push down
and release ignitor button. This will light
pilot. The pilot is attached to the rear of
the front burner. If needed, keep pressing
ignitor button until pilot lights.
Note: If pilot does not stay lit, contact a
qualified service person or gas supplier
for repairs. Until repairs are made, light
pilot with match.
7. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
Note: If pilot goes out, repeat steps 3
through 7, page 14.
8. Turn control knob counterclockwise
to the ON position. Burner should
light. If burner does not light, call a quali-
fied service person.
9. To leave pilot lit and shut off burners only,
turn control knob clockwise
PILOT position.
• Keep the area around the log set clean and
clear of debris.
• Occasionally, you may use a soft bristle
brush to clean logs.
126904-01A
OPERATION

CLEANING AND MAINTENANCE

www.SuperiorFireplaces.US.com
Continued
Figure 19 - Ignitor and Control Knob
Pilot
Burner
Figure 20 - Thermocouple and Pilot
1. Turn control knob clockwise
PILOT position.
2. Press in and turn control clockwise
to the
to the OFF position.
3. Close equipment shutoff valve.
• Once every year a qualified agency or certi-
fied chimney sweep should examine and
clean the venting system of the fireplace.
Control Knob Pilot
Ignitor
ON
FROM "PILOT" POSITION
SLIGHT PUSH TO
On
Thermocouple
TO TURN OFF GAS
TO APPLIANCE
OFF
Off
TURN OFF
PULL PUSH
TO LIGHT
to the
15