Selecting The Color Temperature; Using Cableclear ® Digital Noise Reduction; Using Mpeg Noise Reduction - Toshiba Regza 42RV535U Owner's Manual

52RV535U_EN.book Page 57 Tuesday, July 22, 2008 5:25 PM
4
To save the new settings, highlight Done and press
T.
To revert the factory defaults, highlight Reset and
press T.
Note: If you select one of the factory-set picture modes
(Sports, Standard, Movie, or PC) and then change the
static gamma setting, the picture mode automatically
changes to Preference.

Selecting the color temperature

You can change the quality of the picture by selecting
from three preset color temperatures (Cool, Medium,
and Warm), as described below.
Mode Picture Quality
Cool blueish
Medium neutral
Warm reddish
To select the color temperature:
1
From the Video menu, highlight Picture Settings
and press T.
2
Highlight Advanced Picture Settings and press
T.
3
Highlight Color Temperature and press T.
4
In the Color Temperature field, select the mode you
prefer (Cool, Medium, or Warm).
5
Press B or b to select either B Drive or G Drive, and
then press C or c to adjust the settings.
B Drive: c makes the picture blueish.
•
G Drive: c makes the picture greenish.
•
Note: The B Drive and G Drive settings are connected to
the Color Temperature settings and will change based
on which setting is selected in step 4 above.
6
To save the new settings, highlight Done and press
T.
To revert to the factory defaults, highlight Reset and
press T.
Note: If you select one of the factory-set picture modes
(Sports, Standard, Movie, or PC) and then change the
color temperature mode, the picture mode automatically
changes to Preference.
Chapter 7: Using the TV's advanced features
Using CableClear
The CableClear
you to reduce visible interference in your TV picture.
This may be useful when receiving a broadcast with a
weak signal (especially a Cable channel) or playing a
noisy video cassette or disc.
To change the CableClear settings:
1
From the Video menu, highlight Noise Reduction
and press T.
2
In the CableClear field, select your desired setting.
Note:
• If the current input is ANT/CABLE, Video 1, or Video 2,
• If the current input is ColorStream HD1, ColorStream
3
To save the new settings, highlight Done and press
T.
To revert to the factory defaults, highlight Reset and
press T.

Using MPEG noise reduction

The MPEG noise reduction feature allows you to reduce
visible interference caused by MPEG compression.
Choices for MPEG noise reduction are Off, Low, Middle,
and High. Off is automatically selected when this feature
is disabled ("grayed out").
To select the MPEG noise reduction level:
1
From the Video menu, highlight Noise Reduction
and press T.
2
Press B or b to highlight the MPEG Noise
Reduction field, and then press C or c to select
either Off, Low, Middle or High.
3
To save the new settings, highlight Done and press
T.
To revert to the factory defaults, highlight Reset and
press T.
®
digital noise reduction
®
digital noise reduction feature allows
the menu will display the text "CableClear." The
available selections are Off, Auto, Low, Middle, and
High.
HD2, HDMI 1, HDMI 2, HDMI 3, or HDMI 4, the menu
will display the text "DNR." The available selections are
Off, Auto, Low, Middle, and High. Auto will react
proportionally to the strength of the noise. Low, Middle,
and High will reduce the noise in varying degrees, from
lowest to highest, respectively.
(continued)
57
RV535U (E/F) Web 213:276