Regza Link Pc Link; Using The Hdmi Settings Feature; Regza Link Setup - Toshiba Regza 42RV535U Owner's Manual

52RV535U_EN.book Page 54 Tuesday, July 22, 2008 5:25 PM
To set the REGZA LINK Setup:
1
From the Setup menu, highlight REGZA LINK
Setup and press T.
2
Press B or b to highlight Enable REGZA LINK.
3
Press C or c to select On.
Note: If you set Enable REGZA LINK to Off, the other
items will be grayed out.
4
Press B or b to highlight the REGZA LINK setup
item you want to use, and press C or c to select On
or desired mode.
TV Auto Input Switch: On/Off
•
TV Auto Power: On/Off
•
Device Auto Standby: On/Off
•
Speaker Preference: TV Speakers/Audio Receiver
•
5
To save the new settings, highlight Done and press
T.
To revert to the factory defaults, highlight Reset and
press T.

REGZA LINK PC Link

This feature automatically sets suitable widescreen
formats and picture preferences when the TV is
connected to a REGZA LINK PC.
Note:This feature depends on the type of equipment
connected.
54
Chapter 6: Using the TV's features

Using the HDMI settings feature

This menu consists of the following items (new HDMI
capabilities) and will be grayed out on non-HDMI
inputs.
Some HDMI legacy sources may not work properly with
your HDMI TV, please try setting the following options
(Lip-Sync Latency and Deep Color) to Off. Adjusting
these settings should allow your HDMI legacy source to
operate properly with your TV.
Note: You must disconnect your source device first before
settings can be adjusted.
Lip-Sync Latency: On
•
This option activates an auto audio/video display
timing adjustment function that allows HDMI source
devices to accurately perform synchronization
automatically.
Deep Color: On (46" and 52" models only)
•
This feature allows the HDMI source to increase
available colors bits within the boundaries defined by
the RGB or YCbCr color space.
Both of the above HDMI settings need proper HDMI
source devices. If an HDMI source device does not
support these features, the TV may not work properly
when these features are enabled.
Note: If your HDMI connection is capable of 1080p and/or
your TV is capable of refresh rates greater than 60Hz or
supports Deep Color, you will need a High Speed HDMI cable.
Conventional HDMI/DVI cables may not work properly with this
mode.
To set the HDMI Settings:
1
Select the appropriate HDMI input mode (HDMI 1,
HDMI 2, HDMI 3, or HDMI 4).
2
From the Setup menu, highlight HDMI Settings and
press T.
3
Press B or b to highlight the item you want to set.
4
Press C or c to select On or Off .
5
To save the new settings, highlight Done and press
T. To revert to the factory defaults, highlight Reset
and press T.
RV535U (E/F) Web 213:276