Adjusting the projected image
Adjusting the image height
The projector is equipped with 2 adjuster feet. These adjusters change the image height.
To adjust the projector:
•
Screw the adjuster feet to adjust the image
height.
•
To retract the feet, screw the adjuster feet in
reverse direction.
If the projector is not placed on a flat surface or
the screen and the projector are not
perpendicular to each other, the projected image
becomes trapezoidal. To correct this situation, see
"Correcting keystone" on page 30
•
Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyes.
•
Be careful when you screw the adjuster foot as it is close to the exhaust vent where hot air
comes from.
Fine-tuning the image clarity
Rotate the focus ring to sharpen the image.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality.
•
Using the remote control
Press AUTO.
Within 3 seconds, the built-in Intelligent Auto
Adjustment function will re-adjust the values of
Frequency and Clock to provide the best picture
quality.
The current source information will be displayed
on the upper left corner of the screen for 3
seconds.
This function is only available when PC signal (analog RGB) is selected.
for details.
Operation 29