Installing/Removing A Smartcard Reader (Optional); Installing The Smartcard Reader; Removing The Smartcard Reader - Fujitsu ESPRIMO C7xx Operating Manual

Installing/removing a SmartCard reader (optional)

Operation of this module is not permitted in Taiwan.
In systems equipped with a SmartCard reader, access can be restricted to those
users who have a corresponding SmartCard.

Installing the SmartCard reader

SmartCardreader
► Open the casing (see
► Break out the web at the SmartCard opening on the front cover.
► Connect the cable for the SmartCard reader to the mainboard and the SmartCard
reader. Refer to the manual for the mainboard.
► Install the drive cage again (see
► Close the casing (see

Removing the SmartCard reader

SmartCardreader
► Open the casing (see
Fujitsu
"Opening the casing", Page
1
"Installing the drive cage", Page
"Closing the casing", Page
"Opening the casing", Page
2
34).
► Remove the drive cage (see
the drive cage", Page
► Slide the SmartCard reader into the
bay provided for it (1) and secure it
with the two screws (2).
► Make sure that the SmartCard reader
is also between the two brackets.
Otherwise, you will not be able to insert
the SmartCard from outside.
38).
35).
34).
► Remove the drive cage (see
the drive cage", Page
► Disconnect the SmartCard connector
from the mainboard. Refer to the
manual for the mainboard.
► Loosen the screws (1).
► Pull the SmartCard reader out of the bay (2).
► Install the drive cage again (see
the drive cage", Page 38
► Close the casing (see
casing", Page 35).
System expansions
"Removing
37)
"Removing
37)
"Installing
"Closing the
45